 |
|
|||||||
|
||||||||
 4. Survey and prepare the model using the ø2.3mm drill bit w/ a drill press. Then insert a 2.3mmø X 20mm guide pin halfway into prepared site to get an ideal drilling trajectory. Secure the guide pin with super glue or wax. |
 5. Soften the template in water for about a minute untill it turns just transparent and malleable (do not overheat). |
 6. Slide the template over the secured guide pin and conform its softened base to the adjacent teeth of the edentulous ridge. |
 7. Allow template to cool down untill it turns opaque. Remove it from model and cold sterilize it in an appropriate disinfectant (do not autoclave). |
| <<Previous Next>> | |
|
Copyright , All Rights Reserved
|